How to change drum in brother printer

How do you reset the drum on a Brother printer?

FAQs & Troubleshooting

  1. Close the front cover.
  2. Make sure the machine is turned on.
  3. Press. (Settings). …
  4. Press All Settings. (This step might be skipped in some models.)
  5. Choose Machine Info. or Machine Information => Parts Life.
  6. Press and hold Drum or Drum Life until the machine’s display message changes.
  7. Press Yes.
  8. Press.

Do I need to replace the drum on my Brother printer?

The Brother machine will display a ‘Replace Drum’ or ‘Drum Stop’ message when the machine has printed approximately 15,000 pages. The drums should be replaced as a set in order to maintain print quality. Unlike the toner cartridges, the drum change is not automatically detected by the machine when they are replaced.

Why does my Brother printer keep saying replace drum?

Without a chip, your drum unit has no way of being able to associate itself with your Brother printer. As a result, you will get the “Replace Drum” message because your printer thinks that you’ve not installed a drum unit. On the right is a standard toner cartridge with a chip.27 мая 2014 г.

How do you replace the drum on a Brother MFC l8850cdw?

Replacing the drum unit

Press the front cover release button and then open the front cover. Hold the blue handle of the drum unit. Pull the drum unit out until it stops. Turn the blue lock lever (1) at the left of the machine counterclockwise to the release position.

What happens if you don’t replace printer drum?

Many consumers have the “If it ain’t broke, don’t fix it” mentality. But the replacement of a drum unit is vital to laser printers’ health. A degraded drum unit can cause streaks, smudges, and blank spots on your printed page even if you just inserted a new printer toner.

You might be interested:  How to clear printer in error state

How do I clean the drum on my Brother printer?

Turn the drum unit as shown in the illustration. Make sure that the drum unit gear is on the left side. Turn the edge of the drum unit toward you by hand while looking at surface of the suspected area. Wipe the surface of the drum gently with a dry cotton swab until the mark on the surface comes off.

What are the signs that a printer drum needs to be replaced?

  • Blurry Prints. If your printer is churning out blurry pages, it either means that your printer drum is damaged and in need of replacement or that you need new ink toner. …
  • Black Spots. …
  • Poor Print Quality. …
  • Other Signs and Symptoms.

How long does a Brother printer drum last?

approximately 15,000 pages

How do I know if my printer drum needs to be replaced?

Separate drum units last quite a bit longer than a toner cartridge and typically should be replaced after the use of 3-4 toners. Your printer should inform you when it’s time to replace the drum, but you can usually tell your drum is on it’s last legs if you start to see black spots or lines across the page.

Is a printer drum the same as toner?

The two most important components of a laser printer are the toner cartridge and the drum unit which is where the question of drum units vs. toner cartridges comes in. … So, the toner cartridge is the container that holds toner particles while the drum unit is the component that holds the image that needs to be printed.

You might be interested:  How to add a shared printer

How often do printer drums need to be replaced?

10,000 to 50,000

How do you reset the drum on a Brother MFC 9340cdw?

Brother MFC-9340CDW – Reset Drum

  1. Press “X” to clear the error message.
  2. Press the tools button (picture of a spanner).
  3. Press “All Settings”.
  4. Press “Machine Info”.
  5. Press “Parts Life”.
  6. Press “#” until the touch screen message changes.
  7. Press the colour of the drum that was replaced.
  8. Press “Yes”.

Leave a Reply

Your email address will not be published. Required fields are marked *