FAQ

What is the drum on a brother printer

What is the drum unit on a Brother printer?

What is the drum unit? The drum unit transfers the toner to the paper. The laser printer puts the toner on the roller called “The photosensitive drum” inside the drum unit, and then prints letters and images by fixing toner to the paper by heat and pressure.

How do you reset the drum on a Brother printer?

FAQs & Troubleshooting

  1. Close the front cover.
  2. Make sure the machine is turned on.
  3. Press. (Settings). …
  4. Press All Settings. (This step might be skipped in some models.)
  5. Choose Machine Info. or Machine Information => Parts Life.
  6. Press and hold Drum or Drum Life until the machine’s display message changes.
  7. Press Yes.
  8. Press.

Do I need to replace the drum on my Brother printer?

The Brother machine will display a ‘Replace Drum’ or ‘Drum Stop’ message when the machine has printed approximately 15,000 pages. The drums should be replaced as a set in order to maintain print quality. Unlike the toner cartridges, the drum change is not automatically detected by the machine when they are replaced.

How do you check the drum on a Brother printer?

You can view your current drum’s remaining life on your Brother machine’s LCD by following these steps.

  1. Press MENU and choose Machine Info. => Drum Life.
  2. Press the OK key. Your Brother machine’s LCD will display the percentage of remaining drum life.
  3. Press the STOP/EXIT key.

What happens if you don’t replace printer drum?

The drum then picks up toner in the areas where it is charged and transfers it to the paper. An electrical charge in the printer then resets the drum’s charge so that it can print again. Over time, the drum’s chemicals can lose their effectiveness and the drum’s surface can be damaged.

You might be interested:  Hp printer is offline how to fix

How long should a drum last in Brother printer?

approximately 15,000 pages

How do I clean the drum on my Brother printer?

Turn the drum unit as shown in the illustration. Make sure that the drum unit gear is on the left side. Turn the edge of the drum unit toward you by hand while looking at surface of the suspected area. Wipe the surface of the drum gently with a dry cotton swab until the mark on the surface comes off.

What do I do when my printer says replace drum?

Make sure that the printer is on and open the front cover. Remove the toner cartridge and drum unit from the machine.

Once the new drum is replaced, you will need to reset the drum counter:

  1. Open the front cover.
  2. Press and hold OK for 2 seconds.
  3. Press the Up arrow key or 1 to reset the drum counter.

What are the signs that a printer drum needs to be replaced?

The most obvious is most common on laser color printers and can be detected by a flashing message on the printer display screen. Other signs of a bad printer drum include printing blank pages, printing gray pages and strange sounds coming from the printer as it prints.

How do I know if my printer drum needs to be replaced?

The drum unit may need replacing if you notice the printer producing blurry, low-quality images. Black or colored toner spots on printouts also indicates a failing drum unit. In some cases, horizontal lines may develop across the printout every time the paper passes the failing part of the drum.

You might be interested:  How to connect printer to windows 10

Is toner and drum the same thing?

The two most important components of a laser printer are the toner cartridge and the drum unit which is where the question of drum units vs. toner cartridges comes in. … So, the toner cartridge is the container that holds toner particles while the drum unit is the component that holds the image that needs to be printed.

Leave a Reply

Your email address will not be published. Required fields are marked *